S-Click PRESENCE DETECTOR SLAVE FOR CPD-360P CPD-360P-SLAVE

Description

Slave device for use with the high performance 2 channel presence detector (part no. CPD-360P)

Off delay settings: CH 1 (lighting) 5 sec to 30 min, CH 2 (HVAC) 10 sec to 60min

30m detection zone, up to 10 slaves extend detection zone even further

Recessed or surface mount with junction box included

Optional IR remote control

Product Description

The CPD-360P-SLAVE is a slave unit for use in connection with the CPD-360P PIR presence detector. The product is suitable for lighting or HVAC automation control and
is designed to extend the detection coverage provided by the master device.

A slave detector works as a movement register to send a signal to the master detector. Under this mode, load will perform according to the settings of the master
sensor. Up to 10 slave units can be attached to each CPD-360P. Refer to the product datasheet for a visual diagram of the detection coverage that this system
provides.

The CPD-360P-SLAVE is suitable for halogen, fluorescent and LED lighting, and features impulse mode for switching a staircase timer. The device has a 360-degree
detection angle with a detection lens shield to allow for the angle to be adjusted. Suitable for flush mounting or surface mounting with the included junction box.

Operating Specifications and Technical Data

Detection Angle: 360 degrees

Detection Range: Diameter 30M

Environmental Protection: IP40 (IP54 with junction box included)

Operating Temperature: -20 to +45 degrees Celsius

Electrical Data

Rated Voltage: 220 – 240V ~ 50/60HZ

Technical Specifications

Detection Range (m): 30

Number of Channels: 2

Mounting Type: Surface, Ceiling

Surface Mount: No

Ceiling Mount: No

Lamp Compatibility: Incandescent, Halogen, Fluoroscent, LED, Energy Saving